2A3 Push Pull Amp



This is my Amplifier. It is a Push Pull design with parallel 2A3 tubes. So there are four 2A3 in the output stage. Phase splitter is a 53 and input is a 56. It is a complete triode design.
This amp was made by LOESCH & WIESNER in the USA.

Here is the amp schematic.
Click on the picture to get a larger one.
Use the "Backbutton" of your browser to get back.
Here is the heater schematic.
Click on the picture to get a larger one.
Use the "Backbutton" of your browser to get back.


Back


This page is optimised for 1024*768 viewing area. I take no responsibility for the accuracy of information in these pages, or consequences of doing something stupid after reading these pages. (c) Ulrich Haumann, 1999 - 2003
The Homepage of this article you find under WWW.PLASMATWEETER.DE